Spectra Precision Focus 30 - Page 126

Chapter 4
Troubleshooting
Focus 30/35 Service Manual 4 - 40 P/N 79000035_SM, Version 1.5
06 H-angle sensor measurement
failed
H angle sensor reading error
A A1
Drive system Turn event
error warning 6 B D1
FI: 20 Code: 0x9c54
Message: Angle
measurement faile
FI: 10 Code: 0xf002
Message: Angle
measurement failed
Error: 0x9868 (39016) brown
out reset dedected
Fsmxfile Hz: reading error 6
A = error
LED right or left demaged
Exchange Base unit.
07 Subsystem error:Angle H
H-Angle sensor not
communicating 1 2 3 4 A A1
Drive system Turn event
error warning 6 B D1 C C1
FI: 10 Code: 0xf005
Message: 3|99|0|199998400|-
100|PositionHV faile
FI: 10 Code: 0xf001
Message: Axis: 0 B1: 1 B2: 0
LB blocke
Check the cable Hz-ACB.
08 H-angle measurement failed
(after turning alhidade)
Reading disturbed C D
Drive system Turns blocked
6 D D1
FI: 10 Code: 0xf002
Message: Angle
measurement failed
FI: 20 Code: 0x9c54
Message: Angle
measurement faile
FI: 10 Code: 0xf005
Message: 2|99|0|92162700|-
61791800|PositionHV faile
Clean the Hz-glass circle
09 Servofocus adjusted failed
Adjustment failed A
FI: 1 Code: 0x9c53 Message:
Reject SF MoveTo because
SF is not online
FI: 50 Code: 0x9c50
Message: SF Adjust failed
10 Subsystem error Tilt
Tilt sensor not
communicating 1 2 3 4 A A1
Drive system not enough
turns D1 oder Turn command
failed 6A A1 B D D1 C
FI: 10 Code: 0x9c52
Message: Req x6e got res 9
FI: 10 Code: 0xf005
Message: 1|99|99|21605038|-
5046|PositionHV faile
FI: 1 Code: 0x9c4e Message:
Tilt sensor: Not
communicating, FI 35 0x9c4f
Tilt retry ini.
Check the cable
Exchange the Tilt sensor
Item System Monitor messages
and message codes stored in
*.fsmx file
Error Log stored in
*.irep file
Recommendation