11.The Setup Summary screen displays the settings that were configured by the
wizard. Verify that the settings are correct and that no errors display in the
Done column. If you need to modify any settings or fix any issues, either click
Back to reach the applicable screen or Cancel out of the wizard to fix the issues
and return later. When the setting are all correct, click Finish. The Configuration
> Encryption screen displays (see Figure57 on page110).
12.Use the Set Encryption Mode per Partition pane to select KMIP as the encryption
mode for the desired partition(s) and then click Submit.
—OR—
If you want all partitions to use KMIP Encryption, select KMIP as the default
encryption mode, click Apply to all existing partitions, and click Submit.
JANUARY 2023 118
SPECTRA STACK LIBRARY
USER GUIDE
CHAPTER 3 - CONFIGURING AND USING ENCRYPTION
To Next Page
Loading...
