14215700-IG, Edition 8.0
April 2018, Original document
10
About This Guide
This guide is intended for qualified technicians who will install, configure and maintain the Spectralink
IP-DECT Server 200/400/6500 solution. To qualify to install the Spectralink IP-DECT Server
400/6500 solution, you must have successfully completed the Spectralink IP-DECT Server
400/6500 technical training. The guide provides all the necessary information for successful install-
ation and maintenance of the wireless solutions.
This includes the installation and configuration of:
l Spectralink IP-DECT Server 200/400/6500
l Spectralink DECTMedia Resource (only Spectralink IP-DECT Server 6500)
l Spectralink IP-DECT Base Station (only Spectralink IP-DECT Server 400/6500)
l Spectralink DECT Repeater
The guide also provides you with information about:
l Web based Administration Page of the Spectralink IP-DECT Server 200/400/6500, Spec-
tralink DECTMedia Resource, and Spectralink IP-DECT Base Station.
Important Information Before You Begin
This guide assumes the following:
l that users have a working knowledge of the call handler’s operations
l that the call handler is installed, initialized and is working correctly
l that you have a working knowledge of deployment in general
l that a site survey has been conducted and that the installer has access to these plans
Note:
The site survey should determine the number of handsets, base stations and repeaters
are needed and where to place them. The site survery should also determine how many
RF channels are needed.
Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide
To Next Page
Loading...
