SpectraLink IP-DECT 200 - Configuring Security Settings and Changing System Password; Administrator Authentication Settings

14215700-IG, Edition 8.0
April 2018, Original document
99
Configuring Security Settings and Changing System
Password
It is recommended to change the password for the devices. To change the password and other
security settings from the web based Administration Page of the different devices (server, base sta-
tions and media resources):
1. Click Configuration, and then click Security.
2. On the Security Configurationpage, enter the following data:
Field Setting
Security Configuration - Administrator Authentication
Current password Enter the current password.
New username Enter a new username.
New password (Optional) Enter a new password.
New password again
(Optional)
Enter the new password again to confirm.
Strict password requirements
(Optional)
If enabling strict password requirements, the device can
be configured to enforce certain security rules and naming
conventions. For more information, see "Strict Password
Requirements" on the next page.
Note: Once enabled, this setting can only be disabled by a
factory reset (Configuration > Factory Reset) that will
remove all configuration and user data.
Password expiration (Optional) Select when you want the password to expire.
Possible values: Never, 30 days or 90 days.
Default value: Never
Note: Once enabled, this setting can only be disabled by a
factory reset (Configuration > Factory Reset) that will
remove all configuration and user data.
Security Configuration - Data protection
Allow unencrypted HTTP
(Optional)
HTTPS is forced by default.
If enabled, HTTP support is supported instead of HTTPS.
Note: Enabling unencrypted HTTP can cause passwords
and other sensitive data to be transmitted in clear text on
the network.
Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide