14215700-IG, Edition 8.0
April 2018, Original document
98
To Configure SNMP Settings
1. Click Configuration, and then click General.
2. On the General Configuration page, enter the following data:
Field Setting
General Configuration - SNMP
Enabled
(Optional)
If enabled, access to the SNMP is allowed, and the server will respond to
SNMP requests.
Community
(Optional)
SNMP Community name (public). The server will respond to requests
from a manager in this community.
Trap host
(Optional)
Address of SNMP trap host to which SNMP traps are sent.
Trap community
(Optional)
SNMP trap Community name used for sending traps.
System location
(Optional)
Information about the physical location of this host.
E.g. telephone closet, 3rd floor
System contact
(Optional)
The textual identification of the contact person for this host, together with
information about how to contact them.
3. Click Save.
Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide
To Next Page
Loading...
