SpectraLink IP-DECT 200 - Setting Up Static IP Addresses

14215700-IG, Edition 8.0
April 2018, Original document
93
To Configure a Static IP Address and Other Network Settings
It is highly recommended to use a static IP address for the Spectralink IP-DECT Server and Spec-
tralink DECTMedia Resource.
To configure IP address, DNS and NTP settings for the Spectralink IP-DECT Server and Spec-
tralink DECTMedia Resource from the web based Administration Page:
1. Click Configuration, and then click General.
2. On the General Configuration page, enter the following data:
Field Setting
General Configuration - IPv4
Method Default value: DHCP assigned (dynamic IP address)
Select Use Static IP Address to configure a static IP
address.
Note: When using a static IP address, it is also neces-
sary to configure other network settings below such as
DNS and NTP settings.
For more information, see also "Recommended Network
Configuration" on page85.
IP addr Enter the IP address of the Spectralink IP-DECT Server.
Netmask Enter a new network mask. Contact your system admin-
istrator for more information.
Gateway Enter the IP address of the default gateway.
The default gateway serves as an access point to
another network.
Contact your system administrator for more information.
MTU (Maximum Translation
Unit) (Optional)
Enter the size of the largest packet, that your network pro-
tocol can transmit.
Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide