14215700-IG, Edition 8.0
April 2018, Original document
202
Configuring Handset Login
Enable/Disable Handset Login on Spectralink IP-DECT Server
1. Ensure that support of the relevant call handler is enabled (Configuration > relevant Call
handler (e.g. Skype for Business)).
2. Click Configuration, and then click Wireless Server.
3. On the Wireless Server Configuration page, under Handsets, enable the handset sharing
features Handset sharing and Handset login:
Field
Wireless Server Configuration - DECT
Subscription allowed (Optional) If enabled, it is possible to subscribe new handsets to
the system.
Authenticate calls (Optional) If enabled, each individual DECT call will be authen-
ticated.
Encrypt voice/data (Optional) Encryption of voice/data packets transmitted via
DECT.
Possible values: Disabled, Enabled or Enforced
(non GAP).
Default value: Disabled
System access code (Optional) System wide DECT access code.
The access code is from 0 - 8 decimal digits.
Note: Individual user access code (AC) has pre-
cedence over system access code.
Send date and time (Optional) If enabled, date and time will be sent to the handsets
when a call is terminated.
Default value: Enabled
System TX power (Optional) Used for controlling (reducing) the output power of all
connected base stations supporting power control.
Unless set to default, this will override any base station
specific power setting.
Default value: Default (250 mW)
Note: It is possible to define a TX power value for a
specific base station (Administration > Base Sta-
tion).
Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide
To Next Page
Loading...
