Field Setting
Click Save.
Update base station firmware - Manual
Firmware file (Optional) The firmware file can be either a previously uploaded default
firmware file, or a new firmware file chosen. A new firmware file
has to be a valid firmware file with the extension .bin.
Select either Default or Upload.
Start base station No The index number of the first base station to be updated.
You can check base station numbers under Administration >
base stations > IP Base Stations.
End base station No The index number of the last base station to be updated.
Field Setting
Handset update settings - Automatic update
Enable (Optional) Enable.
This will make automatic update possible.
Only in charger (Optional) If enabled, only handsets in charger will be updated.
Start time (Optional) Default value: Immediately
If you want to upload later, select an appropriate time within
the next 24 hours.
System load (Optional) Select relevant upload capacity. The load corresponds to the
number of maximum simultaneous updates.
Possible values: Low, Medium or High.
Default value: Medium
Low: 1 handset at a time. Medium: 4 handsets per media
resource. High: 16 handsets per media resource.
Example: 2 media resources and High load = 2*16 = 32 sim-
ultaneous updates.
Note: If you schedule an upgrade during day hours, you
would typically choose Low to Medium load to avoid any
impact on Users. Upgrade after hours typically means no
User load, therefore, you can choose High priority.
To Previous Page
Loading...
