14215700-IG, Edition 8.0
April 2018, Original document
49
Installing the Spectralink IP-DECT Server
200
Below you will find information about installing the server.
Note:
Before you install the equipment, ensure that a site planner defines the location of the
server.
Before you begin the installation, determine the position of the server for best coverage.
The average coverage within buildings is 75 meters/245 feet.
The coverage depends on the construction of the building, architecture, and the choice of
building materials.
Power Requirements for the Spectralink IP-DECT
Server 200
l Power over Ethernet (PoE 802.3af).
l Maximum power supply consumption is 3.0W (IEEE 802.3af class 1 device).
Use a standard PoE adapter or a PoE-enabled port on an ethernet switch adhering to PoE 802.3af
when connecting the Spectralink IP-DECT Server 200 to a PoE power source.
Use an 8V-DC power supply when using a port without PoE.
Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide
To Next Page
Loading...
