14215700-IG, Edition 8.0
April 2018, Original document
86
Assigning DHCP Server Options
Note:
Not relevant to the Spectralink IP-DECT Server 200.
This section provides you with information on basic network configuration of the Spectralink IP-
DECT Server 400/6500 solution and the web based Administration Page.
You can provide information about the static IP address of Spectralink IP-DECT Server 400/6500 in
the DHCP server through DHCP options. When defining the IP address of the Spectralink IP-DECT
Server 400/6500 in the DHCP server, all media resources and Spectralink IP-DECT Base Stations
are configured automatically.
The media resources and Spectralink IP-DECT Base Stations will include a Vendor Class Identifier
option (60) with the value KIRK.IP6000 and a request for the Vendor Specific Information option
(43) in the initial DHCP Discover request.
In the DHCP offer message, it will then expect the address of the Spectralink IP-DECT Server loc-
ation in the Vendor Specific Information option (43), sub-option 43 encpapsulated as a string type
parameter.
On a Windows Server 2012 DHCP Management Cosole, the following steps will configure the cor-
rect DHCP option:
1. Right-click IPv4/IPv6, and click Define Vendor Classes....
2. Add a class new class:
l Display name: IP-DECT
l Description: Spectralink IP-DECT
l ASCII: KIRK.IP6000 (case sensitive)
3. Right-click IPv4/IPv6, and click Set Predefined Options....
4. Add a new option in the IP-DECT class:
l Name: IP-DECT Server
l Type: String
l Code: 43
l Description: IP address of the IP-DECT Server
5. Right-click Server Options, and click Configure Options.
6. Under Advanced, add option 43 in the Spectralink IP-DECT vendor class, and set the value
to the IP address of the Spectralink IP-DECT Server.
Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide
To Next Page
Loading...
