14215700-IG, Edition 8.0
April 2018, Original document
120
Assigning Base Stations to Clusters
To make use of the created cluster entities, these must be assigned to the physical media resources
and base stations. The devices can be both local and remote.
1. Click Administration, and then click Base Station.
2. On the Base Stations page, click on the relevant base station.
3. On the Base Station page, under General in the Cluster field, select the desired cluster:
Field
Base Station - General
IP address (Read only) Current IP address of the base station.
Description (Optional) Enter a description.
It is recommended to use a description of the physical loc-
ation.
RPN Radio Part Number of the base station.
Cluster Default value: Default
It is possible to cluster devices that are located at the
same location.
To assign a cluster to the base station, select the relevant
cluster from the list.
For information about defining clusters, see "Configuring
Clusters" on page118.
Disabled (Optional) If enabled, the base station will be disabled.
Note: If Add new as active is enabled (Configuration
> Wireless Server > Base stations), then this will be
unset by default when adding a new base station.
TX power (Optional) Used for controlling the output power for this specific
base station.
Select another value from the list, if you need to change
the output power.
Default value: Default (250 mW)
Note: If a system TX power other than default is set for
the whole system (Configuration > Wireless Server>
DECT), that setting will override this setting.
Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide
To Next Page
Loading...
