14215700-IG, Edition 8.0
April 2018, Original document
47
Installation Prerequisites
Note:
Ensure that a site survey and deployment have been conducted and that the installer has
access to these plans before proceeding any further. For more information about deploy-
ment, see the Synchronization and Deployment Guide for the Spectralink IP-DECT
Server 400/6500 or theIP-DECT Server 200 Deployment and Installation Configuration
Guidedepending on your installation.
Before you start the installation, you need to find the following information and perform the following
tasks:
l ARI for the Spectralink IP-DECT Server (see label on the rear of the server unit)
For more information, see "Identifying ARI on Spectralink IP-DECT Server" on the next page.
l Serial numbers for handsets.
For more information, see "Identifying IPEI on Spectralink Handset" on the next page.
l AC (Authentication Codes)
The AC is a customer-defined optional subscription pin code of a maximum of eight digits for
the individual handset. The AC can be used when connecting the handset to the server.
l Repeaters:
Mark each repeater with the number of the related base station (or Spectralink IP-DECT
Server 200/400). This way you can easily configure the system on site.
l Handsets:
To use the handsets, you must first install the radio infrastructure, e.g. base stations and
repeaters to transmit and receive radio signals to and from the handsets. There are no direct
connections between the handset and the system.
l Charging battery
When charging the handset battery for the first time, leave the handset in the charger for 14 -
16 hours to ensure that the battery is fully charged and the handset ready for use. For more
information about the handset, refer to the user guide available online at http://sup-
port.spectralink.com/products.
Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide
To Next Page
Loading...
