14215700-IG, Edition 8.0
April 2018, Original document
84
Configuring the Spectralink IP-DECT
Server/Spectralink DECTMedia Resource
Solution
This section provides you with information on basic network configuration of the Spectralink IP-
DECT Server 200/400/6500/Spectralink DECTMedia Resource solution and the web based Admin-
istration Page.
Note:
Configuration of Spectralink DECTMedia Resources and Clusters is not relevant to the
Spectralink IP-DECT Server 200/400.
Configuration of Spectralink IP-DECT Base Stations is not relevant to the Spectralink IP-
DECT Server 200.
The web based Administration Page is used to configure the different components of the Spectralink
IP-DECT Server solution.
Basic network settings can be obtained the following ways:
l From a DHCP server
Using DHCP the device requests and obtains an available IP address from a DHCP server.
The device also obtains other parameters such as the default gateway, subnet mask, DNS
server, Time server and other IP parameters from the DHCP server.
l Entered manually through web based Administration Page > Configuration > General >
General Configuration page.
Using manual network configuration, the IP-addresses and other networking parameters are
entered manually through the web based Administration Page.
Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide
To Next Page
Loading...
