SpectraLink IP-DECT 200 - Administration - Base Station - Base Station

14215700-IG, Edition 8.0
April 2018, Original document
256
Administration - Base Station - Base Station
Field
Base Station - General
IP address (Read only) Current IP address of the base station.
Description (Optional) Enter a description.
It is recommended to use a description of the physical loc-
ation.
RPN Radio Part Number of the base station.
Cluster Default value: Default
It is possible to cluster devices that are located at the same
location.
To assign a cluster to the base station, select the relevant
cluster from the list.
For information about defining clusters, see "Configuring
Clusters" on page118.
Disabled (Optional) If enabled, the base station will be disabled.
Note: If Add new as active is enabled (Configuration >
Wireless Server > Base stations), then this will be unset
by default when adding a new base station.
TX power (Optional) Used for controlling the output power for this specific base
station.
Select another value from the list, if you need to change the
output power.
Default value: Default (250 mW)
Note: If a system TX power other than default is set for the
whole system (Configuration > Wireless Server> DECT),
that setting will override this setting.
Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide