SpectraLink IP-DECT 200 - Status - Network Diagnose; Configuration - General

14215700-IG, Edition 8.0
April 2018, Original document
226
Status - Network Diagnose
Field
Network Diagnose
Host Enter the relevant IP address or domain name.
Click Ping to send a ping request to the host to check if net-
work is connected.
Click Trace route if you want to trace the route to the host.
Configuration - General
Field Setting
General Configuration - IPv4
Method Default value: DHCP assigned (dynamic IP address)
Select Use Static IP Address to configure a static IP address.
Note: When using a static IP address, it is also necessary to
configure other network settings below such as DNS and NTP
settings.
For more information, see also "Recommended Network Con-
figuration" on page85.
IP addr Enter the IP address of the Spectralink IP-DECT Server.
Netmask Enter a new network mask. Contact your system administrator
for more information.
Gateway Enter the IP address of the default gateway.
The default gateway serves as an access point to another net-
work.
Contact your system administrator for more information.
MTU (Maximum Translation
Unit) (Optional)
Enter the size of the largest packet, that your network protocol
can transmit.
Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide