Field Setting
Update base station firmware - Default
PCS Information about default firmware file version (PCS) - if a firm-
ware file has been uploaded.
Note: Once uploaded, default firmware will remain on the
server until overwritten.
Note: If the Use firmware as default check box on the
Update firmware page is enabled (Firmware > Wireless
Server or Configuration > Provisioning > Firmware), then
the server firmware is uploaded as default for all base stations
and media resources (recommended). For the files to be
updated in the base station, this must be executed either
through manual update or automatic update.
Build Information about the build number of default firmware file - if a
default firmware file has been uploaded.
Update base station firmware - Automatic
Enable (Optional) Default value: Disabled
Enable this, if you want to make automatic update possible. The
base stations will be automatically updated using the default
firmware. Also new base stations automatically update to new
default firmware when connected.
Note: If the default firmware version changes, the update pro-
cess will start automatically according to the chosen values in
the Force and Start time fields.
Note: Using provisioning for base stations, media resources
and handsets, enabling automatic update is required. This can
be done either through the XML configuration file or the web
based Administration Page. For more information, see Pro-
visioning Guide.
Force (Optional) When Force is enabled, the base stations will be updated at the
selected Start time.
If Force is disabled, the base stations will be updated when
they become idle after the selected Start time.
Start time (Optional) Default value: Immediately
If you want to upload later, select an appropriate time within the
next 24 hours.
To Next Page
Loading...
