SpectraLink IP-DECT 200 - To Update Spectralink DECT Media Resource Firmware

14215700-IG, Edition 8.0
April 2018, Original document
157
To Update Spectralink DECTMedia Resource Firmware
Note:
Not relevant to the Spectralink IP-DECT Server 200/400.
Once uploaded, default firmware will remain on the server until overwritten or deleted. New firmware
can be uploaded either through provisioning (license required) or manually.
Note:
Media resources can use default firmware, if selected when server firmware is uploaded.
For more information, see "To Update Spectralink IP-DECT Server Firmware" on
page153.
1. Click Firmware, and then click MediaResource.
2. On the Update media resource firmware page, enter the following data:
Field Setting
Update media resource firmware - Default
PCS Information about default firmware file version (PCS) - if a firm-
ware file has been uploaded.
Note: Once uploaded, default firmware will remain on the
server until overwritten.
Note: If the Use firmware as default check box on the
Update firmware page is enabled (Firmware > Wireless
Server or Configuration > Provisioning > Firmware), then
the server firmware is uploaded as default for all base stations
and media resources (recommended). For the files to be
updated in the media resource, this must be executed either
through manual update or automatic update.
Build Information about the build number of default firmware file - if a
default firmware file has been uploaded.
Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide