SpectraLink IP-DECT 200 - LAN Port on Face Plate; Spectralink IP-DECT Server 200 Reset Button; Wall-Mount and Power on the Spectralink IP-DECT Server

14215700-IG, Edition 8.0
April 2018, Original document
52
LAN Port on Face Plate
LED Indicator Meaning
LINK Indicator - yellow Link layer software has established connection.
LINK Indicator - green flashing Activity
Spectralink IP-DECT Server 200 Reset Button
You can restart or reset the Spectralink IP-DECT Server 200 by pressing the Reset button on the
bottom of face plate of the server.
The following table contains a description of the different actions that take place when pressing the
Reset button.
Press button Action
Short press (2 to 5 sec.) System restarts when button is released.
Long press (5 to 9 sec.) until front LED
flashes red, then release button
Resets the system to factory default settings (original IP
settings - DHCP) and restarts the system. Firmware ver-
sion is not affected.
Wall-Mount and Power on the Spectralink IP-DECT
Server 200
For best RF coverage, the Spectralink IP-DECT Server 200 must be mounted vertically on walls.
1. Mount the Spectralink IP-DECT Server 200 on the wall using the anchors and screws accom-
panying the product.
Note:
When you place the Spectralink IP-DECT Server 200 on the screws, ensure that
the screws do not touch the printed circuit board.
Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide