Field Setting
Redundancy Configuration - Node type
Single If selected, this will disable redundancy and configure for stand
alone (normal single server solution).
Select Single, if this device is to be a normal single server solu-
tion.
Master If enabled, this will enable redundancy and configure the device
as master server. The system will be controlled by this device.
Select Master, if this device is to be the master server.
Slave If enabled, this will enable redundancy and configure the device
as backup (slave) server. The device will be controlled by a mas-
ter server.
Select Slave, if this device is to be the backup server.
Redundancy Configuration - Peer node
Address If master server, enter the fixed IP address or hostname for the
backup Spectralink IP-DECT Server 6500.
If backup server, enter the fixed IP address or hostname for the
master Spectralink IP-DECT Server 6500.
Redundancy Configuration - System identification
UUID (Optional) The UUID (unique ID) of the redundant system. This must be
the same for master server and backup server for replication to
be performed. The master server automatically generates the
UUID.
Note: When reset on the master server, the UUID is auto-
matically generated, and when reset on the backup server, it is
retrieved from the master server. The UUID must be reset
when a master Spectralink IP-DECT Server 6500 is changed
to a backup Spectralink IP-DECT Server 6500, or when a
backup Spectralink IP-DECT Server 6500 is moved to another
solution.
Reset UUID (Optional) If enabled, the UUID is reset if the UUID of the master server
and backup server is not matching.
To Next Page
Loading...
