Field
External antenna mode
(Optional)
Determines which antenna(s) are used when an external
antenna is connected.
Possible values: Use Internal & external antenna,
Use internal antenna only or Use external antenna
only.
Default value: Use Internal & external antenna
Note: This setting is ignored when no external antenna is
connected.
Note: When using external antenna, the range is
reduced by up to 50 %.
Base Station - Synchronization
Type This setting controls the synchronization type used for
the specific base station/DECT radio.
Possible values: Free running, Radio, LAN or Radi-
o/LAN Gateway.
Select Free running, if you want to configure this base
station as sync master. Otherwise select either Radio,
LAN or Radio/LAN Gateway, depending on the syn-
chronization method.
Default value: Radio
Note: System wide settings for synchronization are loc-
ated under Configuration > Wireless Server > Base
stations.
For more information, see Synchronization and Deploy-
ment Guide.
Auto radio sync (deployment
only) (Optional)
If enabled, the base station will be auto synchronized
while deploying the system.
Note: This must only be used while deploying the sys-
tem.
Primary radio sync (RPN)
(Optional)
RPN identifying the base station used for primary radio
synchronization.
Secondary radio sync (RPN)
(Optional)
RPN identifying the base station used for secondary
radio synchronization.
To Next Page
Loading...
