1. Click Configuration, then click Wireless Server.
2. On the Wireless Server configuration page, under Base stations, set the desired syn-
Field
Wireless Server Configuration - DECT
Subscription allowed (Optional) If enabled, it is possible to subscribe new handsets to
the system.
Authenticate calls (Optional) If enabled, each individual DECT call will be authen-
ticated.
Encrypt voice/data (Optional) Encryption of voice/data packets transmitted via
DECT.
Possible values: Disabled, Enabled or Enforced
(non GAP).
Default value: Disabled
System access code (Optional) System wide DECT access code.
The access code is from 0 - 8 decimal digits.
Note: Individual user access code (AC) has pre-
cedence over system access code.
Send date and time (Optional) If enabled, date and time will be sent to the handsets
when a call is terminated.
Default value: Enabled
System TX power (Optional) Used for controlling (reducing) the output power of all
connected base stations supporting power control.
Unless set to default, this will override any base station
specific power setting.
Default value: Default (250 mW)
Note: It is possible to define a TX power value for a
specific base station (Administration > Base Sta-
tion).
Wireless Server Configuration - Media resources (Not relevant to the Spectralink IP-
DECT Server 200/400)
Allow new (Optional) If enabled, new media resources are allowed to con-
nect to the server.
To Next Page
Loading...
