Field Setting
Update base station firmware - Automatic
Enable (Optional) Default value: Disabled
Enable this, if you want to make automatic update possible. The
base stations will be automatically updated using the default
firmware. Also new base stations automatically update to new
default firmware when connected.
Note: If the default firmware version changes, the update pro-
cess will start automatically according to the chosen values in
the Force and Start time fields.
Note: Using provisioning for base stations, media resources
and handsets, enabling automatic update is required. This can
be done either through the XML configuration file or the web
based Administration Page. For more information, see Pro-
visioning Guide.
Force (Optional) When Force is enabled, the base stations will be updated at the
selected Start time.
If Force is disabled, the base stations will be updated when
they become idle after the selected Start time.
Start time (Optional) Default value: Immediately
If you want to upload later, select an appropriate time within the
next 24 hours.
Click Save.
Update base station firmware - Manual
Firmware file (Optional) The firmware file can be either a previously uploaded default
firmware file, or a new firmware file chosen. A new firmware file
has to be a valid firmware file with the extension .bin.
Select either Default or Upload.
Start base station No The index number of the first base station to be updated.
You can check base station numbers under Administration >
base stations > IP Base Stations.
End base station No The index number of the last base station to be updated.
To Next Page
Loading...
