Symbol DS7708 - Convert Case

666 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

6 - 20 DS7708 2D Vertical Slot Scanner Product Reference Guide

Convert Case

When enabled, the scanner converts all bar code data to the selected case.

Options:

•

*No Case Conversion

•

Convert All To Upper Case

•

Convert All To Lower Case.

*No Case Conversion

Convert All to Upper Case

Table of Contents

DS7708 2D VERTICAL SLOT SCANNER PRODUCT REFERENCE GUIDE1
- Warranty4
- Revision History5
Table of Contents7
ABOUT THIS GUIDE19
- Introduction19
- Scanner Configurations19
- Accessories20
- Chapter Descriptions22
- Notational Conventions23
- Related Publications24
- Service Information24
GETTING STARTED27
- Introduction27
- Unpacking the Scanner27
  - Protective Cover27
- Features28
- Setting Up the Scanner30
- Mounting the Scanner (Optional Hardware Required)34
- Operating the Scanner37
- Wall Mount Template38
- Table Mount Template39
DATA CAPTURE41
- Overview41
- Scanning Bar Codes on Products42
  - Active Scan Area42
- Decode Ranges43
- User Indicators44
  - Beeper Volume/ Beeper Tone44
  - LED and Beeper Indicators44
- Electronic Article Surveillance (EAS)47
  - Installing47
MAINTENANCE, TECHNICAL SPECIFICATIONS, MOUNTING TEMPLATES49
- Introduction49
- Maintenance49
- Troubleshooting50
- Technical Specifications52
- Scanner Signal Descriptions55
USER PREFERENCES & MISCELLANEOUS OPTIONS57
- Introduction57
- Scanning Sequence Examples58
- Errors While Scanning58
- User Preferences/Miscellaneous Options Parameter Defaults58
- User Preferences60
- Miscellaneous Scanner Parameters83
IMAGING PREFERENCES95
- Introduction95
- Scanning Sequence Examples96
- Errors While Scanning96
- Imaging Preferences Parameter Defaults96
- Imaging Preferences98
USB INTERFACE125
- Introduction125
- Connecting a USB Interface126
- USB Default Parameters128
- USB Host Parameters129
- Optional USB Parameters155
  - Beep Directive155
  - Bar Code Configuration Directive156
- ASCII Character Set for USB157
RS-232 INTERFACE169
- Introduction169
- RS-232 Host Parameters173
- ASCII Character Set for RS-232205
IBM 468X/469X INTERFACE211
- Introduction211
- Connecting to an IBM 468X/469X Host212
- IBM Default Parameters214
- IBM 468X/469X Host Parameters215
KEYBOARD WEDGE INTERFACE221
- Introduction221
- Connecting a Keyboard Wedge Interface222
- Keyboard Wedge Default Parameters224
- ASCII Character Set for Keyboard Wedge239
SSI INTERFACE249
- Introduction249
- Communications249
- SSI Transactions251
  - General Data Transactions251
    - ACK/NAK Handshaking251
  - Transfer of Decode Data252
- Communication Summary253
- Things to Remember When Using SSI Communication254
- Encapsulation of RSM Commands/Responses Over SSI255
  - Command Structure255
  - Response Structure255
- Simple Serial Interface Default Parameters256
- SSI Parameters258
- Event Reporting279
AUXILIARY SCANNER283
- Connecting an Auxiliary Scanner283
- Programming the Auxiliary Scanner283
  - Downloading Firmware283
- 12VDC Power Requirement284
- Using Auxiliary Scanners284
SYMBOLOGIES287
- Introduction287
- Scanning Sequence Examples287
- Errors While Scanning287
- Symbology Parameter Defaults288
- Enable/Disable All Code Types294
- UPC/EAN295
  - Enable/Disable UPC-A295
  - Enable/Disable UPC-E296
  - Enable/Disable UPC-E1297
  - Enable/Disable EAN-8/JAN-8298
  - Enable/Disable EAN-13/JAN-13299
  - Enable/Disable Bookland EAN300
  - Bookland ISBN Format301
  - Decode UPC/EAN/JAN Supplementals302
  - User-Programmable Supplementals310
  - UPC/EAN/JAN Supplemental Redundancy311
  - UPC/EAN/JAN Supplemental AIM ID Format312
  - UPC Reduced Quiet Zone314
  - Transmit UPC-A Check Digit315
  - Transmit UPC-E Check Digit316
  - Transmit UPC-E1 Check Digit317
  - UPC-A Preamble318
  - UPC-E Preamble320
  - UPC-E1 Preamble322
  - Convert UPC-E to UPC-A324
  - Convert UPC-E1 to UPC-A325
  - EAN-8/JAN-8 Extend326
  - UCC Coupon Extended Code327
  - Coupon Report328
  - ISSN EAN330
- Code 128331
  - Enable/Disable Code 128331
  - Set Lengths for Code 128332
  - Enable/Disable GS1-128 (formerly UCC/EAN-128)335
  - Enable/Disable ISBT 128336
  - ISBT Concatenation337
  - Check ISBT Table339
  - ISBT Concatenation Redundancy340
  - Code 128 Reduced Quiet Zone341
  - Code 128 Security Level342
  - Ignore Code 128 <FNC4>344
  - Enable/Disable Code 39345
  - Enable/Disable Trioptic Code 39346
  - Convert Code 39 to Code 32347
  - Code 32 Prefix348
  - Set Lengths for Code 39349
  - Code 39 Check Digit Verification352
  - Transmit Code 39 Check Digit353
  - Code 39 Full ASCII Conversion354
  - Code 39 Security Level355
  - Code 39 Reduced Quiet Zone357
- Code 93358
  - Enable/Disable Code 93358
  - Set Lengths for Code 93359
  - Code 11362
  - Set Lengths for Code 11363
  - Code 11 Check Digit Verification366
  - Transmit Code 11 Check Digits368
- Interleaved 2 of 5 (ITF)369
  - Enable/Disable Interleaved 2 of 5369
  - I 2 of 5 Check Digit Verification373
  - Transmit I 2 of 5 Check Digit375
  - Convert I 2 of 5 to EAN-13376
  - I 2 of 5 Security Level377
  - I 2 of 5 Reduced Quiet Zone379
  - Discrete 2 of 5 (D 2 of F)380
  - Set Lengths for Discrete 2 of 5381
- Codabar (NW - 7)384
  - Enable/Disable Codabar384
  - Set Lengths for Codabar385
  - CLSI Editing388
  - NOTIS Editing389
  - Codabar Upper or Lower Case Start/Stop Characters Detection390
- MSI391
  - Enable/Disable MSI391
  - Set Lengths for MSI392
  - MSI Check Digits395
  - Transmit MSI Check Digit(s)396
  - MSI Check Digit Algorithm397
- Chinese 2 of 5398
  - Enable/Disable Chinese 2 of 5398
- Matrix 2 of 5399
  - Enable/Disable Matrix 2 of 5399
  - Set Lengths for Matrix 2 of 5400
  - Matrix 2 of 5 Check Digit402
  - Transmit Matrix 2 of 5 Check Digit403
- Korean 3 of 5404
  - Enable/Disable Korean 3 of 5404
- Inverse 1D405
- Postal Codes407
  - US Postnet407
  - US Planet408
  - Transmit US Postal Check Digit409
  - UK Postal410
  - Transmit UK Postal Check Digit411
  - Japan Post412
  - Australia Post413
  - Australia Post Format414
  - Netherlands KIX Code416
  - USPS 4CB/One Code/Intelligent Mail417
  - UPU FICS Postal418
- Inverse 1D419
- GS1 DataBar421
  - GS1 DataBar Limited422
  - GS1 DataBar Expanded423
  - GS1 DataBar Limited Security Level424
  - Convert GS1 DataBar to UPC/EAN426
- Composite427
  - Composite CC-C427
  - Composite CC-A/B428
  - Composite TLC-39429
  - UPC Composite Mode430
  - Composite Beep Mode432
  - GS1-128 Emulation Mode for UCC/EAN Composite Codes434
- 2D Symbologies435
  - Enable/Disable PDF417435
  - Enable/Disable MicroPDF417436
  - Code 128 Emulation437
  - Data Matrix438
  - Data Matrix Inverse439
  - GS1 Data Matrix441
  - Decode Mirror Images (Data Matrix Only)442
  - Maxicode444
  - QR Code445
  - QR Inverse446
  - GS1 QR448
  - MicroQR449
  - Aztec450
  - Aztec Inverse451
  - Han Xin453
  - Han Xin Inverse454
- Redundancy Level456
  - Redundancy Level 1456
  - Redundancy Level 2456
  - Redundancy Level 3456
  - Redundancy Level 4457
- Security Level459
  - Intercharacter Gap Size461
  - 1D Quiet Zone Level462
- Macro PDF Features464
  - Flush Macro Buffer464
  - Abort Macro PDF Entry465
OCR PROGRAMMING467
- Introduction467
- OCR Parameter Defaults468
- OCR Programming Parameters469
123SCAN2513
- Introduction513
- Communication with 123Scan2513
- 123Scan2 Requirements514
- Scanner SDK, Other Software Tools, and Videos514
ADVANCED DATA FORMATTING515
- Introduction515
STANDARD DEFAULT PARAMETERS517
COUNTRY CODES529
- Introduction529
- USB and Keyboard Wedge Country Keyboard Types (Country Codes)530
COUNTRY CODE PAGES581
- Introduction581
- Country Code Page Defaults582
- Country Code Page Bar Codes586
CJK DECODE CONTROL611
- Introduction611
- CJK Control Parameters612
- Unicode/CJK Decode Setup with Windows Host620
PROGRAMMING REFERENCE623
- Symbol Code Identifiers623
- AIM Code Identifiers625
SAMPLE BAR CODES631
- Code 39631
- UPC/EAN631
  - UPC-A, 100%631
  - EAN-13, 100%632
- Code 128632
- Interleaved 2 of 5632
- GS1 DataBar-14633
- PDF417633
- Data Matrix633
- Maxicode633
- QR Code634
- Han Xin634
- US Postnet634
- UK Postal634
NUMERIC BAR CODES635
- Numeric Bar Codes635
  - 0635
  - 1635
  - 2636
  - 3637
  - 4638
  - 5639
  - 6640
  - 7641
  - 8642
  - 9643
- Cancel644
SIGNATURE CAPTURE CODE645
- Introduction645
- Code Structure645
  - Signature Capture Area645
  - CapCode Pattern Structure646
- Start / Stop Patterns646
- Dimensions647
- Data Format647
- Additional Capabilities648
- Signature Boxes648
NON-PARAMETER ATTRIBUTES649
- Introduction649
- Attributes649
INDEX655
Tell Us What You Think...663

Related product manuals

Preview: Symbol DS4308

Preview: Symbol DS3578

Preview: Symbol LS2208

Preview: Symbol LS3578

Preview: Symbol CS4070

Preview: Symbol LS4278

Preview: Symbol CS3070

Preview: Symbol LS1203

Preview: Symbol LS1902-T

Symbol LS1902-T