SYMBOLOGIES 12 - 63
Set Lengths for Code 39
SSI # L1 = 12h, L2 = 13h
Parameter # L1 = 18, L2 = 19
The length of a code refers to the number of characters (i.e., human readable characters), including check
digit(s) the code contains. Set lengths for Code 39 to any length, one or two discrete lengths, or lengths within
a specific range. If Code 39 Full ASCII is enabled, Length Within a Range or Any Length are the preferred
options. The supported range for Code 39 lengths is 0 - 99; the default range is 2 - 55.
Options:
•
Code 39 One Discrete Length - Select this option to decode only Code 39 symbols containing a selected
length. Select the length using the numeric bar codes in Appendix G, NUMERIC BAR CODES. For
example, to decode only Code 39 symbols with 14 characters, scan Code 39 -
One Discrete Length,
then scan 1 followed by 4. To correct an error or change the selection, scan Cancel on page G-10.
•
Code 39 Two Discrete Lengths - Select this option to decode only Code 39 symbols containing either
of two selected lengths. Select lengths using the numeric bar codes in Appendix G, NUMERIC BAR
CODES. For example, to decode only Code 39 symbols containin
g either 2 or 14 characters, select
Code 39 - Two Discrete Lengths, then scan
0, 2, 1, and then 4. To correct an error or change the
selection, scan Cancel on page G-10.
•
*Code 39 Length Within Range - Select this option to decode a Code 39 symbol with a specific
length range. Select lengths using numeric bar codes in Appendix G, NUMERIC BAR CODES. For
exa
mple, to decode Code 39 symbols containing between 4 and 12 characters, first scan Code 39
-
Length Within Range. Then scan 0, 4, 1, and 2 (enter a leading zero for single digit numbers). To
correct an error or change the selection, scan Cancel on page G-10.
•
Code 39 Any Length - Select this option to decode Code 39 symbols containing any number of
characters within the scanner’s capability.
NOTE When setting lengths for different bar code types, enter a leading zero for single digit numbers.
To Next Page
Loading...
