Symbol DS7708 - STANDARD DEFAULT PARAMETERS

APPENDIX A STANDARD DEFAULT
PARAMETERS
Table A-1 Standard Default Parameters Table
Parameter SSI Number
1
Parameter
Number
2
Default
Page
Number
User Preferences
Set Default Parameter N/A N/A Set Defaults 4-4
Parameter Bar Code Scanning ECh 236 Enable 4-6
Beep After Good Decode 38h 56 Enable 4-7
Beeper Tone 91h 145 High 4-9
Beeper Volume 8Ch 140 High 4-12
Beeper Duration F1h 74h 628 Medium 4-13
Volume/Tone Button Control F8h 05h 07h 1287 Enable 4-15
Suppress Power-up Beeps F1h D1h 721 Do not suppress 4-17
Timeout Between Decodes, Same
Symbol
89h 137 0.5 Sec 4-18
Timeout Between Decodes, Different
Symbols
90h 144 0 Sec 4-18
Fuzzy 1D Processing F1h 02h 514 Enable 4-19
Decode Mirror Images (Data Matrix
Only)
F1h 19h 537 Auto 4-21
PDF Prioritization F1h CFh 719 Disable 4-22
PDF Prioritization Timeout F1h D0h 720 200 ms 4-22
Mobile Phone/Display Mode F1h CCh 716 Enable 4-24
1
SSI number hex values are used for programming via SSI commands.
2
Parameter number decimal values are used for programming via RSM commands.