Symbol DS7708 - Removing the Scanner from the Mounting Bracket

1 - 10 DS7708 2D Vertical Slot Scanner Product Reference Guide
5. Place the mounting bracket in position over the drilled holes with its flat surface facing the mounting
surface.
6. Figure 1-11 - 2: Insert four screws (provided) through the holes and fasten to the mounting surface.
7. Figure 1-12 - 3: Invert the scanner slightly and align the mounting slots over the plastic tabs on the bracket.
8. Figure 1-12 - 4: Insert the plastic tabs into the mounting slots on the scanner, and slide the scanner back
until it clicks into place.
9. Figure 1-12 - 5: To secure the scanner in the bracket, insert the thumb screw (provided) through the hole in
the bottom of the bracket and fasten to the scanner bottom.
Removing the Scanner from the Mounting Bracket
To remove the scanner:
1. Grasp the scanner firmly on both sides.
2. Slide the scanner forward and lift out.