4 - 18 DS7708 2D Vertical Slot Scanner Product Reference Guide
Timeout Between Decodes, Same Symbol
SSI # 89h
Parameter # 137
Use this option to prevent the beeper from continuously beeping when a symbol is left in the scanner’s field of
view. It is programmable in 0.1 second increments from 0.0 to 9.9 seconds. The default interval is 0.5 seconds.
To select the timeout between decodes for
the same symbol, scan the bar code below, then scan two numeric
bar codes from Appendix G, NUMERIC BAR CODES that correspond to the desired interv
al, in 0.1 second
increments.
Timeout Between Decodes, Same Symbol
Timeout Between Decodes, Different Symbols
SSI # 90h
Parameter # 144
Use this option in to control the time the scanner is inactive between decoding different symbols. It is
programmable in 0.1 second increments from 0 to 9.9 seconds. The default is 0 seconds.
To select the timeout between decodes for different symbols, scan the
bar code below, then scan two numeric
bar codes from Appendix G, NUMERIC BAR CODES that correspond to the desired interv
al, in 0.1 second
increments.
Timeout Between Decodes, Different Symbols
To Next Page
Loading...
