GETTING STARTED 1 - 11
Operating the Scanner
Indicator Lights
The scanner includes an array of three bi-color (green/red) LEDs to display system status and alerts. Center
LED conditions: Off, Dim, Full; Outer LED conditions: Off, Full.
Adjusting Speaker Volume
To change the volume of the beep, scan the a bar code in the section Beeper Volume on page 4-11, or use the
two-function Volume/Tone
button on the front of the scanner (see Figure 1-2 on page 1-2).
Press and release the Volume/Tone
button repeatedly until the desired volume level sounds (high, medium or
low).
Adjusting Speaker Tone
To change the tone of the beep, scan the a bar code in the section Beeper Tone on page 4-8, or use the
two-function Volume/Tone
button on the front of the scanner (see Figure 1-2 on page 1-2).
Press and hold the Volume/Tone
button for three seconds to change to a different tone. Repeat this process
until the desired tone sounds (high, medium, low or medium to high tone).
NOTE If the decode tone is set to Off, the Volume/Tone button cannot be used to change the decode tone. To allow
the tone change using the Volume/Tone button, scan a tone other than Off.
If the Volume/Tone Button Control parameter is set to Disable Volume and Tone Change, the
Volume/Tone button on the scanner cannot be used to change the volume and tone of the beeps.
To Next Page
Loading...
