Symbol DS7708 - FN1 Substitution Values

4 - 36 DS7708 2D Vertical Slot Scanner Product Reference Guide
FN1 Substitution Values
Key Category SSI # 67h
Decimal Value SSI # 6Dh
Key Category Parameter # 103
Decimal Value Parameter # 109
The wedge and USB HID keyboard hosts support a FN1 Substitution feature. Enabling this substitutes any
FN1 character (0x1b) in an EAN128 bar code with a value. This value defaults to 7013 (Enter key).
When using host commands to set the FN1 substitution value, set the k
ey category parameter to 1, then set
the 3-digit keystroke value. See the ASCII character set table for the current host interface for the desired
value.
To select a FN1 substitution value
via bar code menus:
1. Scan the Set FN1 Substitution Value bar code below.
2. Locate the keystroke desired for FN1 substitution in the ASCII character set table in the appropriate host
interface chapter. Enter the 4-digit ASCII value by scanning each digit in Appendix G, NUMERIC BAR
CODES.
To correct an error or change the selection, scan Cancel on page G-10.
See USB Keyboard FN1 Substitution on page 6-17 to enable FN1 substitution for the USB HID keyboard.
Set FN1 Substitution Value