SYMBOLOGIES 12 - 73
Set Lengths for Code 93
SSI # L1 = 1Ah, L2 = 1Bh
Parameter # L1 = 26, L2 = 27
The length of a code refers to the number of characters (i.e., human readable characters), including check
digit(s) the code contains. Set lengths for Code 93 to any length, one or two discrete lengths, or lengths within
a specific range. The supported range for Code 93 lengths is 0 - 55; the default range is 1 - 55.
Options:
•
Code 93 One Discrete Length - Select this option to decode only Code 93 symbols containing a selected
length. Select the length using the numeric bar codes in Appendix G, NUMERIC BAR CODES. For
example, to decode only Code 93 symbols with 14 characters, scan Code 93 -
One Discrete Length,
then scan 1 followed by 4. To correct an error or to change the selection, scan Cancel on page G-10.
•
Code 93 Two Discrete Lengths - Select this option to decode only Code 93 symbols containing either
of two selected lengths. Select lengths using the numeric bar codes in Appendix G, NUMERIC BAR
CODES. For example, to decode only Code 93 symbols containi
ng either 2 or 14 characters, select
Code 93 - Two Discrete Lengths, then s
can 0, 2, 1, and then 4. To correct an error or to change
the selection, scan Cancel on page G-10.
•
*Code 93 Length Within Range - Select this option to decode a Code 93 symbol with a specific
length range. Select lengths using the numeric bar codes in Appendix G, NUMERIC BAR CODES. For
exa
mple, to decode Code 93 symbols containing between 4 and 12 characters, first scan Code 93
-
Length Within Range. Then scan 0, 4, 1, and 2 (enter a leading zero for single digit numbers). To
correct an error or change the selection, scan Cancel on page G-10.
•
Code 93 Any Length - Scan this option to decode Code 93 symbols containing any number of characters
within the scanner’s capability.
To Next Page
Loading...
