SYMBOLOGIES 12 - 99
Set Lengths for Codabar
SSI # L1 = 18h, L2 = 19h
Parameter # L1 = 24, L2 = 25
The length of a code refers to the number of characters (i.e., human readable characters), including check
digit(s) the code contains. Set lengths for Codabar to any length, one or two discrete lengths, or lengths within
a specific range. The supported range for Codabar lengths is 0 - 55; the default range is 4 - 55.
Options:
•
Codabar One Discrete Length - Select this option to decode only Codabar symbols containing a
selected length. Select the length using the numeric bar codes in Appendix G, NUMERIC BAR CODES.
For example, to decode only Codabar symbols with 1
4 characters, scan Codabar - One Discrete
Length, then scan 1 followed by 4. To correct an error or to change the selection, scan Cancel on
page G-10.
•
Codabar Two Discrete Lengths - Select this option to decode only Codabar symbols containing
either of two selected lengths. Select lengths using the numeric bar codes in Appendix G, NUMERIC
BAR CODES. For example, to decode only Codabar symbols containing
either 2 or 14 characters, select
Codabar - Two Discrete Lengths, then scan 0, 2, 1, and then 4. To
correct an error or to change
the selection, scan Cancel on page G-10.
•
*Codabar Length Within Range - Select this option to decode a Codabar symbol with a specific
length range. Select lengths using numeric bar codes in Appendix G, NUMERIC BAR CODES. For
exa
mple, to decode Codabar symbols containing between 4 and 12 characters, first scan Codabar -
Lengt
h Within Range. Then scan 0, 4, 1, and 2 (enter a leading zero for single digit numbers). To
correct an error or change the selection, scan Cancel on page G-10.
•
Codabar Any Length - Scan this option to decode Codabar symbols containing any number of
characters within the scanner’s capability.
Codabar - One Discrete Length
To Next Page
Loading...
