IMAGING PREFERENCES 5 - 5
Snapshot Mode Timeout
SSI # F0h, 43h
Parameter # 323
This parameter sets the amount of time the scanner remains in Snapshot Mode. The scanner exits Snapshot
Mode when you send a soft trigger command, or when the Snapshot Mode Timeout elapses. To set this
timeout value, scan the bar code below followed by a bar code from Appendix G, NUMERIC BAR CODES. The
default value is 0 which represents 30 seconds; values in
cremen
t by 30. For example, 1 = 60 seconds, 2 = 90
seconds, etc.
Snapshot Mode Timeout
To Next Page
Loading...
