SYMBOLOGIES 12 - 25
UPC/EAN/JAN Supplemental Redundancy
SSI # 50h
Parameter # 80
If you selected Autodiscriminate UPC/EAN/JAN Supplementals, this option adjusts the number of times to
decode a symbol without supplementals before transmission. The range is from 2 to 16 times. Five or above is
recommended when decoding a mix of UPC/EAN/JAN symbols with and without supplementals. The default is
10.
Scan UPC/EAN/JAN Supplemen
tal Redundancy below to set a decode redundancy value. Next, scan two
numeric bar codes in Appendix G, NUMERIC BAR CODES. Enter a leading zero for single digit numbers. To
correct an error or change a selection, scan Cancel on page G-10.
UPC/EAN/JAN Supplemental Redundancy
To Next Page
Loading...
