IBM 468X/469X INTERFACE 8 - 3
To set up the DS7708 with an IBM interface:
1. Remove the back cover from the DS7708. See Removing the Back Cover on page 1-5.
2. Plug the host interface cable into the scanner’s host port.
3. Connect the other end of the interface cable to the appropriate port on the host (typically, Port 9).
4. Scan the appropriate bar codes in this chapter, or use 123Scan²
to match the host settings.
5. If using an auxiliary scanner:
a. Connect the auxiliary scanner cable to the auxiliary scanner port on the DS7708.
b. Connect either a CBA-M65-S07ZAR or CBA-M66-S15ZAR 12 volt cable to the host as shown in
Figure 8-2.
6. Replace the DS7708 back cover (see Removing and Replacing the Back Cover on page 1-5).
To Next Page
Loading...
