Symbol DS7708 - Page 290

12 - 4 DS7708 2D Vertical Slot Scanner Product Reference Guide
Code 93
Code 93 09h 9 Disable 12-72
Set Length(s) for Code 93 1Ah, 1Bh 26, 27 1 - 55 12-73
Code 11
Code 11 0Ah 10 Disable 12-76
Set Lengths for Code 11 1Ch, 1Dh 28, 29 4 - 55 12-77
Code 11 Check Digit Verification 34h 52 Disable 12-80
Transmit Code 11 Check Digit(s) 2Fh 47 Disable 12-82
Interleaved 2 of 5 (I 2 of 5)
I 2 of 5 06h 6 Enable 12-83
Set Lengths for I 2 of 5 16h, 17h 22, 23 6 - 55 12-84
I 2 of 5 Check Digit Verification 31h 49 Disable 12-87
Transmit I 2 of 5 Check Digit 2Ch 44 Disable 12-89
Convert I 2 of 5 to EAN 13 52h 82 Disable 12-90
I 2 of 5 Security Level F8h 04h 61h 1121 I 2 of 5 Security Level 1 12-91
I 2 of 5 Reduced Quiet Zone F8h 04h BAh 1210 Disable 12-93
Discrete 2 of 5 (D 2 of 5)
Discrete 2 of 5 05h 5 Disable 12-94
Set Length(s) for D 2 of 5 14h, 15h 20, 21 1 - 55 12-95
Codabar (NW - 7)
Codabar 07h 7 Disable 12-98
Set Lengths for Codabar 18h, 19h 24, 25 4 - 55 12-99
CLSI Editing 36h 54 Disable 12-102
NOTIS Editing 37h 55 Disable 12-103
Codabar Upper or Lower Case Start/Stop
Characters Detection
F2h 57h 855 Up
per Case 12-104
MSI
MSI 0Bh 11 Disable 12-105
Set Length(s) for MSI 1Eh, 1Fh 30, 31 4 to 55 12-106
MSI Check Digits 32h 50 One 12-109
Table 12-1 Parameter Defaults (Continued)
Parameter
SSI
Number
1
Parameter
Number
2
Default
Page
Number
1
SSI number hex values are used for programming via SSI commands.
2
Parameter number decimal values are used for programming via RSM commands.