Symmetricom TimeHub 5500 Reference Manual

1
TimeHub 5500 TL1 Reference Manual
235
Troubleshooting
097-55501-02 Issue 5: June 2003
2
5
3
SSSSSSSSSSSS SSSS S SSSSS SSSSSSS S SSS S SSSSS
5
Expected
connector card
mismatch
ECCRDMM A different connector card exists
than the one specified through the
TL1 command.
1. Use the Retrieve Equipment
command to determine how the
output port group was configured
(RTRV-EQPT::OUTa-PGb:<ctag>
:::PARAMETER=ECONCRD;, where
a is the output card pair and b is the
port group).
2. Change the connector card type, or
reconfigure the output port group
using the Edit Equipment command
(ED-EQPT::OUTa-PGb:<ctag>
:::ECONCRD=c;, where a is the
output card pair, b is the port group,
and c is the connector card type).
Refer to the Keywords chapter for
details on the Output Connector
Card Type (ECONCRD) keyword.
Expected output
protection
mismatch
EPROTMM There are less than two output
driver cards in the indicated output
card pair.
1. Use the Retrieve Equipment
command to determine whether the
output driver card slot was
configured for protection (RTRV-
EQPT::OUTa:<ctag>
:::PARAMETER=EPROT;, where a is
the output card pair).
2. Install another output driver card in
the slot pair, or reconfigure the
output driver card protection using
the Edit Equipment command (ED-
EQPT::OUTa:<ctag>:::EPROT=b;,
where a is the output card pair and
b is the protection requirement).
Refer to the Keywords chapter for
details on the Protection (EPROT)
keyword.
Table M. Message Troubleshooting (cont’d)
Error Message/
Condition
Description Event Code Meaning Action

Symmetricom TimeHub 5500 Specifications

General

Brand	Symmetricom
Model	TimeHub 5500
Category	Data Loggers
Language	English