Technogym Group Cycle D92 - Page 190

10
Figure 218
10. Remove the nut (10) with a 13 mm tubular
box wrench.
Every time you remove the self-locking nut (9)
from the machine: it’s requested to replace
the self-locking nut with the new one. The
self-locking nut must be tightened with a
torque wrench set to 3.9 Nm (2,88 lbf- ft).
11
11
Figure 219
11. Remove the quick-release lever (11).
To reassemble the seat’s horizontal slider and t
back on the bike, follow the aforementioned instruc-
tions in the reverse order.
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed
Page 190