Technogym Group Cycle D92 - Page 62

For equipment produced prior to 2017:therearetwotemplateswithdierentcolours:awhite
template that must be used if there is a white adhesive on the brake, and a black template, to be
used if there is no white adhesive on the brake.
For equipment produced starting from 2017: ONLY use the white template, even if there is no
white adhesive on the brake.
The operations to perform for mechanical product regulation are as follows:
1. Remove the right guard as indicated in § “11.3.1 Removing brake guards” from
point 1 to point 4.
1
2
Figure 35
2. Loosen the knob (1) until the
brake (2) reaches its limit.
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed
Page 62