Technogym Group Cycle D92 - Page 86

5. Check on the terminal , using the command @FWVER#, that the correct SW version was
loaded.
It is very important to carry out this step, because if the incorrect sw is loaded on the new console, the
lewillbetransferredimmediatelytothefolder,butnoerrormessagewillappear.Theconsolewill
turn on and it will seem that everything functions correctly. However if you read the SW version on
the terminal, you will notice that the console will have kept the correct yet obsolete sw that it already
contained.
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed
Page 86