Tektronix Keithley 4200A-SCS - Page 37

Model 4200A-SCS Prober and External Instrument Control Section 2: Using switch matrices
4200A-913-01 Rev. A December 2020 2-25
5. From the Model list, select the appropriate test fixture.
6. Enter the number of pins. You can enter 2 to 72 pins.
The number of pins defined in the test fixture properties determines the pins that are available to
assign to a switch matrix card column. Make sure the number of pins assigned is appropriate for
your system.
Add a probe station
Supported probe stations include:
• Fake Prober
• Manual Prober
• Micromanipulator 8860 Prober
• Cascade Microtech PA200 Prober
• Cascade Summit-12000 Prober
• Signatone CM500 (WL250) Prober
• MPI TS2000, TS2000-DP, TS2000-HP, TS2000-SE, TS3000, and TS3000-SE Probers
Contact Keithley for the most up-to-date list of supported probers. If you are using an unsupported
prober, you must create a user library and module to control it.
To add a probe station to the system configuration:
1. Select Add External Instrument.
2. Select Probe Station.
3. Select OK.
4. In the System Configuration list, select the probe station. The Properties are displayed.