Tektronix Keithley 4200A-SCS - Use Kcon to Add a Prober

Model 4200A-SCS Prober and External Instrument Control Section 9: Using a Cascade Microtech PA200 Prober
4200A-913-01 Rev. A December 2020 9-27
Use KCon to add a prober
On the 4200A-SCS, use KCon to add the prober to the configuration:
1. Open KCon.
2. At the bottom of the System Configuration list, select Add External Instrument. The Add
External Instrument dialog box is displayed.
Figure 170: Add a prober in KCon
3. Select Probe Station.
4. Select OK. KCon displays the properties for the prober.