Tektronix Keithley 4200A-SCS - Use Kcon to Add a Prober

Model 4200A-SCS Prober and External Instrument Control Section 10: Using a Micromanipulator 8860 Prober
4200A-913-01 Rev. A December 2020 10-21
Use KCon to add a prober
On the 4200A-SCS, use KCon to add the prober to the configuration:
1. Open KCon.
2. At the bottom of the System Configuration list, select Add External Instrument. The Add
External Instrument dialog box is displayed.
Figure 214: Add a prober in KCon
3. Select Probe Station.
4. Select OK. KCon displays the properties for the prober.
Figure 215: Use KCon to select a prober