Tektronix Keithley 4200A-SCS - Run the Project and View the Tests

Section 3: Configure and use a Series 700 Switching System Model 4200A-SCS Prober and External Instrument Control
3-16 4200A-913-01 Rev. A December 2020
Run the project and view the tests
To run the project and view the tests:
1. In the project tree, select New Project.
2. Make sure the items in the project tree are checked.
3. Select Run to start the test. The two actions and tests run sequentially. The connectpins
actions set the crosspoints before the tests are executed.
You can select Analyze when you run the project to view test results in real time.
Figure 46: Analyze highlighted
To view the results of a test either as it runs or after it has completed, select the test in the project
tree.