Tektronix Keithley 4200A-SCS - Probesubsites Clarius Project Example; Use Kcon to Add a Prober

Model 4200A-SCS Prober and External Instrument Control Section 11: Using a manual or fake prober
4200A-913-01 Rev. A December 2020 11-7
Figure 230: probesites project tree
6. Click Run.
Probesubsites Clarius project example
The following is a step-by-step procedure to configure the manual prober so the probesubsites
Clarius project executes successfully. The user is responsible for the probe station set-up.
Use KCon to add a prober
On the 4200A-SCS, use KCon to add the prober to the configuration:
1. Open KCon.
2. At the bottom of the System Configuration list, select Add External Instrument. The Add
External Instrument dialog box is displayed.