To Next Page

To Previous Page

Model 4200A-SCS Prober and External Instrument Control Section 10: Using a Micromanipulator 8860 Prober

4200A-913-01 Rev. A December 2020 10-19

Figure 209: Units of measure list

Figure 210: Setup Options window

6. Select Set X, Y die size button in the Setup Options window. The Set X, Y Die size dialog box

opens.

7. If die size is known, enter it. If not known, calculate (see Calculating die sizes (on page 10-17)).

Set spline pattern (optional)

The order of selection of the die, the spline pattern (change using edit die program), and the

reference die location determine test order sequence.

To set spline pattern:

1. Click the Edit Die Program Parameters button on the Die Program Tools window of pcWfr. The

Edit Die Program Parameters window opens.

Figure 211: Die Program Tools window

Tektronix Keithley 4200A-SCS User Manual

Other manuals for Tektronix Keithley 4200A-SCS