To Next Page
K
Kimberly RichardsonSep 12, 2025
Why are alarms not activating on my Topcon X35?
- JjocelynthorntonSep 12, 2025
If alarms are not activating on your Topcon Music Mixer, check alarm settings. In Setup screen go to System/Alarms.
Why are alarms not activating on my Topcon X35?
If alarms are not activating on your Topcon Music Mixer, check alarm settings. In Setup screen go to System/Alarms.
What does it mean if my Topcon X35 Music Mixer screen is white?
If you see a white screen on your Topcon Music Mixer, contact Bourgault dealer.
Why is weight not displaying on remote of my Topcon X35?
If the weight is not displaying on the remote of your Topcon Music Mixer, check the “SCOREM” number and correct if required.
Why does my Topcon X35 monitor automatically turn off?
If the Topcon Music Mixer monitor automatically turns off, check the battery voltage, alternator output, and power cable wiring. Also, verify the fuses and check for any damaged wiring.
How to fix Topcon Music Mixer monitor that will not power up?
If the Topcon Music Mixer monitor will not power up, start the vehicle and check the battery voltage. Also, check for damaged wiring or blown fuse. If the issue persists, there might be a damaged unit and it is advisable to contact Bourgault dealer for repair or replacement.
What to do if Topcon X35 Music Mixer shows error messages on startup?
If the Topcon Music Mixer is showing error messages on startup, contact Bourgault dealer.
What to do if I cannot reach target metering rate on Topcon X35 Music Mixer?
If you cannot reach the target metering rate on your Topcon Music Mixer, ensure metering auger shaft is turning freely (no rubbing or foreign objects in housing). Change to higher range. Lower the rate.
What to do if Topcon Music Mixer display is blank after startup?
If the Topcon Music Mixer is displaying a blank display after startup, contact Bourgault dealer.
What causes intermittent sensor readings on Topcon X35?
If you're experiencing intermittent sensor readings on your Topcon Music Mixer, check harness connections for dirt and/or corrosion and clean as required. Also, ensure proper alignment and gap. Ensure that the speed sensor to target gap is 1/32”-1/8” (1mm- 3mm).
How do I fix Topcon X35 cabin switchbox controls that aren't working?
If the Topcon Music Mixer cabin switchbox controls will not work, go to the Setup screen, then Implement/Operator Inputs and check if keypad switches are enabled.
General| Brand | Topcon |
|---|---|
| Model | X35 |
| Category | Music Mixer |
| Language | English |
