X35 Monitor System Settings
4.12
The X35 console can interact with a GPS that
is used in the following applications: guidance,
variable rate control and mapping. The GPS
signal is also used to determine ground speed (the
preferred method). To access GPS settings from
the Main Setup menu select System/GPS.
Depending on what receiver is being used, the
main GPS menu may have slightly different
options, refer to
Figure 4.13.
Figure 4.13 - GPS Setup Menu
Receiver set to Other
Receiver set to: AGE-1, AGE-2, SGR-1,
AGI-3, or AGI-4
4.2 GPS
To Next Page
Loading...
