How to stop false blockage alarms on Topcon X35?
If you are getting false blockage alarms on your Topcon Music Mixer, check that sensor location on the drill aligns with display on the console. Reconnect or replace the sensor.
What does it mean if my Topcon X35 Music Mixer screen is white?
If you see a white screen on your Topcon Music Mixer, contact Bourgault dealer.
Why is weight not displaying on remote of my Topcon X35?
If the weight is not displaying on the remote of your Topcon Music Mixer, check the “SCOREM” number and correct if required.
Why does my Topcon X35 monitor automatically turn off?
If the Topcon Music Mixer monitor automatically turns off, check the battery voltage, alternator output, and power cable wiring. Also, verify the fuses and check for any damaged wiring.
What does Weight Difference Alarm mean on Topcon Music Mixer?
If the Weight Difference Alarm on your Topcon Music Mixer is indicating theoretical weight change doesn’t match actual, check for air leaks or blockage in tank. Adjust calibration factor for tanks if the actual remaining weight is known.
What to do if displayed weight does not seem accurate on Topcon X35?
If the displayed weight does not seem accurate on your Topcon Music Mixer, check setup and calibration numbers and correct if required. Check wiring and connections from each load cell to the Scale Link ECU. Look for any loose connections, cuts or pinched/flat spots.
What to do if I cannot reach target metering rate on Topcon X35 Music Mixer?
If you cannot reach the target metering rate on your Topcon Music Mixer, ensure metering auger shaft is turning freely (no rubbing or foreign objects in housing). Change to higher range. Lower the rate.
What to do if Topcon Music Mixer display is blank after startup?
If the Topcon Music Mixer is displaying a blank display after startup, contact Bourgault dealer.
What causes intermittent sensor readings on Topcon X35?
If you're experiencing intermittent sensor readings on your Topcon Music Mixer, check harness connections for dirt and/or corrosion and clean as required. Also, ensure proper alignment and gap. Ensure that the speed sensor to target gap is 1/32”-1/8” (1mm- 3mm).
How do I fix Topcon X35 cabin switchbox controls that aren't working?
If the Topcon Music Mixer cabin switchbox controls will not work, go to the Setup screen, then Implement/Operator Inputs and check if keypad switches are enabled.
General| Brand | Topcon |
|---|---|
| Model | X35 |
| Category | Music Mixer |
| Language | English |
To Next Page
