Topcon X35 - Tank Tab;Panel Explained

X35 ConsoleOverview
2.16
2.6.3 Tank Tab/Panel Explained
1. (A) Requested Application Rate - used to enter
and display the application rate. The control
system will use the calibration factor to adjust
the metering auger speed for the given product.
2. (B) Used to decrease requested application rate
by preset increment.
3. (C) Used
to increase requested application rate
by preset increment.
Increase and Decrease functions (+/-) use the same
increment, that can be set in Product Setup (refer
to Section 7 - Product Setup) or when setting up
product
details for the tank (refer to Section 8.1
- Selecting The Product).
4. (D)
Requested Application Rate Preset 1 -
this is the user-defined default application rate.
Selecting this icon will immediately adjust the
application rate to that value.
5. (E)
Requested Application Rate Preset 2 -
this is the user-defined default application rate.
Selecting this icon will immediately adjust the
application rate to that value.
Rate preset 1 and 2 can be set in Product Setup
(refer to Section 7 - Product Setup) or when
setting
up product details for the tank (refer to
Section 8.1 - Selecting The Product).
6. (F)
Tank Metering On/Off toggle - this icon
is Green when the tank is On (metering auger
running), and Red when tank is Off (metering
auger stopped).
7.
(G) Rate Control Mode selector - appears only
when the Variable Rate Control is enabled in
Setup/System/Features/Implement and allows you
to select a VRC or Auto control for a specific
tank or all products, refer to Figure 2.25.
8. (H) Viewing Area 1 - displays data related to
the specific tank. This can be customized to
display up to two parameters. When selected,
a Customize Data window will open with a
list of available parameters to be displayed,
refer to Figure 2.26 and Section 2.6.3.1 - Tank
Parameters. Selected items will have white
background.
Figure 2.23 - Tank Panel - Mini-View
Figure 2.24 - Expanded Tank Panel - Full Screen
Mode
A
B
ED
C
GF
H
H
I
ED
G
F
A
B C
J
K
L
M
N