X35 Monitor Air Seeder Setup
6.60
6.7.4 Pump Settings
These settings appear only if configured with NH3/
Liquid. You can configure settings related to the
liquid/NH3 system pumps.
Systems can have up to 4 pumps. There is a tab
for each pump.
1. Pump
speed - default set to disabled (not
supported
through Bourgault harnessing)
a. "Enable" if you wish to monitor the speed
of the liquid/NH3 system pump.
i. Liquid/NH3 system must be equipped
with a pump speed sensor.
2. Pulses
per revolution - set this to the number
of
targets/resolution that are used by the pump
speed sensor.
Figure 6.79 - Pump Settings
To Next Page
Loading...
